Check Your Propellers Before You Leave
It's "Maintenance Monday", and today we're talking about your boat's propeller(s). If you have an outboard or stern drive boat you should check the propeller as part of your pre-launch routine. Use a deep well socket to remove the propeller several times during the season to make sure discarded fishing line hasn't become wrapped around the propeller shaft. If it has, have your dealer inspect the gear case because fishing line can cause gear case leaks and that is not a do-it-yourself job. While you have the propeller off, inspect it for nicks, dents and other signs of damage. It’s alright if your prop is missing paint, but send it out for repairs if you find signs of impact. The smallest dent can cause your boat to lose performance and burn excessive fuel. A damaged prop also can vibrate, putting too much stress on bearings and seals causing additional damage. Finally, put a liberal amount of waterproof grease on the propeller shaft to prevent corrosion from “freezing” it in place. Then re-install the propeller and hardware in the same order that you took them off. Tighten the nut snugly and secure the locking tabs against the nut so it can’t back off the shaft threads. If you'd like us to either replace or service your boat's propeller(s), call us today at #MarinerServicesInc. at (239)776-4253 for a no-cost, no-obligation consultation!